Jeep 1997 Grand Cherokee Service Manual page 162

OIL SLINGER DRIVER REAR BEAR- ING
3 - 104 DIFFERENTIAL AND DRIVELINE
REMOVAL AND INSTALLATION (Continued)
Fig. 40 Rear Bearing Cup Removal
Fig. 41 Collapsible Spacer
(12) Remove the rear bearing from the pinion with
Puller/Press C-293-PA and Adapters C-293-42 (Fig.
42).
Place 4 adapter blocks so they do not damage
the bearing cage.
(13) Remove the pinion depth shims from the pin-
ion gear shaft. Record the total thickness of the
depth shims.
IBLE SPACER COLLAPS- SHOULDER PINION GEAR HANDLE DRIVE GEAR SHAFT HANDLE ADAPTERS PINION
INSTALLATION
(1) Apply Mopar Door Ease stick lubricant to out-
side surface of bearing cup. Install the pinion rear
bearing cup with Installer C-4308 and Driver Handle
C-4171 (Fig. 43). Ensure cup is correctly seated.
Fig. 43 Pinion Rear Bearing Cup Installation
(2) Apply Mopar Door Ease stick lubricant to out-
side surface of bearing cup. Install the pinion front
bearing cup with Installer D-129 and Handle C-4171
(Fig. 44).
SPECIAL C-293–PA TOOL
Fig. 42 Inner Bearing Removal
INSTALLER VISE
ZG