Passenger Side Airbag Rear Mounting Bracket - Jeep 1997 Grand Cherokee Service Manual

LOWER WIRE RETAINERS TRIM COVER RETAINER INFLATOR
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 6 Horn Switch Feed Wires Remove/Install
Fig. 7 Airbag Trim Cover Retainers Remove/Install
(8) When installing the trim cover and horn
switch, be certain that the locking blocks are fully
engaged on the lip of the airbag housing (Fig. 9).
(9) When installing the upper and lower trim cover
retainers, be certain that the tabs on each retainer
are engaged in the retainer slots of the trim cover
(Fig. 8).
(10) Install and tighten the trim cover retainer
nuts to 10 N·m (90 in. lbs.).
GROUNDWIRE SWITCH HORN STUDS HORN SWITCH FEED AIRBAG NUT (4) UPPER HOUSING RETAINER WIRE HORN SWITCH LOCKING BLOCK AIRBAG HOUSING
Fig. 8 Airbag Trim Cover Remove/Install
Fig. 9 Airbag Trim Cover Locking BlocksInstalled
(11) Reverse the remaining removal procedures to
complete the installation, but do not connect the bat-
tery negative cable at this time. See Airbag System
in Diagnosis and Testing for the proper procedures.
PASSENGER SIDE AIRBAG REAR MOUNTING
BRACKET
(1) Remove the passenger side airbag module as
described in this group.
LOCKING BLOCKS RETAINER SLOTS RETAINER SLOTS TRIM COVER
PASSIVE RESTRAINT SYSTEMS
HORN SWITCH LIP TRIM COVER
8M - 7