Jeep 1997 Grand Cherokee Service Manual page 514

8L - 4 LAMPS
REMOVAL AND INSTALLATION
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 4
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Remove headlamp.
(2) Disengage electrical connector.
(3) Remove protective boot from rear of headlamp
(Fig. 1).
(4) Disengage bulb retaining clip (Fig. 2).
(5) Pull the bulb straight out from the housing.
Fig. 1 Protective Boot
Fig. 2 Retaining Clip
LAMP BULB SERVICE
INDEX
page
REAR FOG LAMP BULB . . . . . . . . . . . . . . . . . . . 5
SIDE REPEATER LAMP BULB . . . . . . . . . . . . . . 4
INSTALLATION
CAUTION:
gers or other oily surfaces. Reduced bulb life will
result.
(1) Position bulb assembly in the lamp housing.
(2) Engage bulb retaining clip.
(3) Install protective boot on rear of headlamp.
(4) Engage electrical connector.
(5) Install headlamp.
SIDE REPEATER LAMP BULB
REMOVAL
(1) Insert a flat blade or similar tool between lamp
and fender opening and pry the lamp away from the
fender (Fig. 3). The retaining tabs are located at the
top and bottom of the lamp.
(2) Twist lamp 1/4 turn clockwise and pull lamp
from socket (Fig. 3).
(3) Twist bulb 1/4 turn and pull bulb from socket.
INSTALLATION
(1) Position bulb in lamp socket and twist bulb 1/4
turn.
(2) Push lamp on socket and turn 1/4 turn counter-
clockwise.
(3) Push lamp into fender opening.
Do not touch the bulb glass with fin-
Fig. 3 Repeater Lamp Lens
ZG
page