Jeep 1997 Grand Cherokee Service Manual page 47

ZG
DESCRIPTION AND OPERATION (Continued)
NOTE: The service procedures and torque specifi-
cations are the same for LHD and RHD vehicles.
The following service procedures and pictures were
developed with a LHD vehicle.
DIAGNOSIS AND TESTING
SHOCK DIAGNOSIS
A knocking or rattling noise from a shock absorber
may be caused by movement between mounting
bushings and metal brackets or attaching compo-
nents. These noises can usually be stopped by tight-
ening the attaching nuts. If the noise persists,
inspect for damaged and worn bushings, and attach-
ing components. Repair as necessary if any of these
conditions exist.
Fig. 1 Front Suspension (LHD)
A squeaking noise from the shock absorber may be
caused by the hydraulic valving and may be intermit-
tent. This condition is not repairable and the shock
absorber must be replaced.
The shock absorbers are not refillable or adjust-
able. If a malfunction occurs, the shock absorber
must be replaced. To test a shock absorber, hold it in
an upright position and force the piston in and out of
the cylinder four or five times. The action throughout
each stroke should be smooth and even.
The shock absorber bushings do not require any
type of lubrication. Do not attempt to stop bushing
noise by lubricating them. Grease and mineral oil-
base lubricants will deteriorate the bushing.
SUSPENSION 2 - 7