Jeep 1997 Grand Cherokee Service Manual page 429

ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 11 Body Control Module Remove/Install
GLOVE BOX MODULE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT
SYSTEMS BEFORE ATTEMPTING STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COM-
PONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT
IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
(1) Remove the knee blocker/steering column cover
as described in this group.
(2) Remove the two screws that secure the top of
the instrument panel center bezel to the instrument
panel above the Graphic Display Module (GDM) or
Vehicle Information Center (VIC).
(3) Remove the ash receiver from the instrument
panel center bezel.
(4) Remove the two screws in the back of the ash
receiver opening that secure the instrument panel
center bezel to the instrument panel armature.
(5) Remove the screw that secures the courtesy
lamp located under the outboard end of the glove box
module.
(6) Open the passenger side front door and remove
the screw that secures the outboard end of the glove
box module.
(7) Remove the four screws that secure the glove
box hinge to the instrument panel armature on the
lower edge of the glove box module.
(8) Open the glove box door and remove the four
screws at the top of the glove box opening that secure
INSTRUMENT PANEL SYSTEMS
the upper edge of the glove box module to the instru-
ment panel armature.
(9) Lower the glove box module far enough to
unplug the wire harness connectors from the glove
box lamp and switch, the cigar lighter and lamp, and
the power outlet. Also remove the ash receiver lamp
bulb and socket as a unit by gently pulling it out of
the ash receiver lamp hood.
(10) Remove the glove box module from the vehi-
cle.
(11) Reverse the removal procedures to install.
GRAPHIC DISPLAY MODULE AND VEHICLE
INFORMATION CENTER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT
SYSTEMS BEFORE ATTEMPTING STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COM-
PONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT
IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
(1) Remove the glove box module as described in
this group.
(2) Remove the three screws that secure the
Graphic Display Module (GDM) or Vehicle Informa-
tion Center (VIC) to the instrument panel armature
(Fig. 12).
Fig. 12 Graphic Display Module and Vehicle
Information Center Remove/Install
(3) Pull the GDM or VIC unit out from the instru-
ment panel far enough to unplug the wire harness
connector.
(4) Remove the GDM or VIC from the instrument
panel.
(5) Reverse the removal procedures to install.
8E - 27