Jeep 1997 Grand Cherokee Service Manual page 516

8L - 6 LAMPS
REMOVAL AND INSTALLATION
HEADLAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
REAR BUMPER REFLECTOR . . . . . . . . . . . . . . . 6
REMOVAL AND INSTALLATION
HEADLAMP
REMOVAL
(1) Remove the park lamp.
(2) Remove the metal clip retaining the upper
pivot of the headlamp to the headlamp leveling
motor.
(3) Pull the headlamp from the grille opening rein-
forcement (GOR).
(4) Disengage the electrical connector from the
rear of the headlamp
INSTALLATION
(1) Engage the electrical connector on the rear of
the headlamp
(2) Position the headlamp in the (GOR) and press
into place.
(3) Install the metal clip retaining the upper pivot
of the headlamp to the headlamp leveling motor.
(4) Install the park lamp.
SIDE REPEATER LAMP
REMOVAL
(1) Insert a small flat blade between lamp and
body panel. Disengage lamp retaining tabs (Fig. 1).
(2) Twist bulb socket 1/4 turn and separate bulb
socket from lamp (Fig. 2).
INSTALLATION
(1) Position socket in lamp and twist socket 1/4
turn.
(2) Position lamp into body opening and push into
place.
REAR FOG LAMP
The rear fog lamp is integrated into the rear tail
lamp. Refer to the Rear Tail Lamp Removal/Installa-
tion procedure.
LAMP SERVICE
INDEX
page
REAR FOG LAMP . . . . . . . . . . . . . . . . . . . . . . . . 6
SIDE REPEATER LAMP . . . . . . . . . . . . . . . . . . . 6
Fig. 1 Repeater Lamp Retaining Tabs
REAR BUMPER REFLECTOR
REMOVAL
(1) From the underside of the vehicle, remove the
nut attaching the reflector to the backside of the rear
bumper.
(2) Separate the reflector from the rear bumper.
Fig. 2 Repeater Lamp
ZG
page