Jeep 1997 Grand Cherokee Service Manual page 166

VISE
SHAFT LOCK SCREW
PINION
THRUST WASHER SPECIAL TOOL 6963–A
3 - 108 DIFFERENTIAL AND DRIVELINE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 55 Differential Case Holding Tool
(7) Assemble Threaded Adapter C–4487–3 into top
side gear. Thread Forcing Screw C–4487–2 into
adapter until it becomes centered in adapter plate.
(8) Position a small screw driver in slot of
Threaded Adapter C–4487–3 (Fig. 59) to prevent
adapter from turning.
Fig. 54 Trac–Lok Differential Components
Fig. 56 Mate Shaft Lock Screw
(9) Tighten forcing screw tool 122 N·m (90 ft. lbs.)
(maximum) to compress Belleville springs in clutch
packs (Fig. 60).
(10) Using an appropriate size feeler gauge,
remove thrust washers from behind the pinion gears
(Fig. 61).
(11) Insert Turning Bar C–4487–4 in case (Fig.
62).
(12) Loosen the Forcing Screw C-4487-2 in small
increments until the clutch pack tension is relieved
and the differential case can be turned using Turning
Bar C-4487-4.
PINION GEAR MATE SHAFT LOCK SCREW
ZG