Jeep 1997 Grand Cherokee Service Manual page 488

8K - 12 WIPER AND WASHER SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(9) Reverse the removal procedures to install.
Tighten the mounting hardware as follows:
• Motor mounting screws - 1 to 1.7 N·m (10 to 15
in. lbs.)
• Motor mounting nut - 4 to 5.6 N·m (35 to 50 in.
lbs.).
WIPER LINKAGE AND PIVOT
The wiper linkage and pivots can only be removed
from or installed in the vehicle as a unit with the
wiper motor. See Wiper Motor in this group for the
service procedures.
INTERMITTENT WIPE RELAY
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the cover from the Power Distribution
Center (PDC) (Fig. 11).
(3) Refer to the label on the PDC for intermittent
wipe relay identification and location.
(4) Unplug the intermittent wipe relay from the
PDC.
(5) Install the intermittent wipe relay by aligning
the relay terminals with the cavities in the PDC and
pushing the relay firmly into place.
(6) Install the PDC cover.
(7) Connect the battery negative cable.
REAR WIPER BLADE BEZEL
Fig. 10 Rear Wiper Motor Remove/Install
POWER DISTRIBUTION CEN- TER
NEGATIVE CABLE NUT NUT NUT G ASKET
Fig. 11 Power Distribution Center
(8) Test the relay operation.
SCREW NUT MOTOR
ZG