Jeep 1997 Grand Cherokee Service Manual page 529

TRANSFER CASE SHIFTER CONSOLE SHIFTER INDICATOR BRACKET BEZEL TRANSFER CASE SHIFTER
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 12 Floor Console Components
(8) Remove the four screws that secure the ACM
mounting bracket to the floor pan transmission tun-
nel (Fig. 14).
(9) Remove the ACM and mounting bracket as a
unit.
(10) When installing the ACM, position the unit
with the arrow on the ACM housing pointing for-
ward.
(11) Attach the ACM to the floor pan transmission
tunnel with the four mounting screws. Tighten the
mounting screws to 10.7 N·m (95 in. lbs.).
(12) Plug in the wire harness connector to the
ACM. Be certain that the connector latches are fully
engaged and that the connector locks are pushed in.
(13) Reverse the remaining removal procedures to
complete the installation.
(14) Do not connect the battery negative cable at
this time. See Airbag System in Diagnosis and Test-
ing for the proper procedures.
CLOCKSPRING
WARNING: THE AIRBAG SYSTEM IS A SENSITIVE,
COMPLEX ELECTROMECHANICAL UNIT. BEFORE
ATTEMPTING TO DIAGNOSE OR SERVICE ANY AIR-
BAG SYSTEM OR RELATED STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
PARKING INDICATOR BRAKE BEZEL FULL PARKING BRAKE CONSOLE
SQUEEZE LATCHES
PULL TWO LOCKS OUT
FLOOR AIRBAG CONTROL MODULE SCREWS (4) AIRBAG CONTROL MODULE PARKING BRAKE LEVER
PASSIVE RESTRAINT SYSTEMS
Fig. 13 Airbag Control Module Connector Removal
Fig. 14 Airbag Control Module Remove/Install
COMPONENTS YOU MUST FIRST DISCONNECT
AND ISOLATE THE BATTERY NEGATIVE (GROUND)
CABLE. THEN WAIT TWO MINUTES FOR THE SYS-
TEM CAPACITOR TO DISCHARGE BEFORE FUR-
THER SYSTEM SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO DO THIS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
FLOOR PAN TRANSMIS- SION TUNNEL
8M - 9