Jeep 1997 Grand Cherokee Service Manual page 474

8J - 4 TURN SIGNAL AND HAZARD WARNING SYSTEMS
REMOVAL AND INSTALLATION
COMBINATION FLASHER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the fuse access panel by unsnapping it
from the right cowl side trim panel.
(3) Remove the push nut that secures the right
cowl side trim panel to the junction block stud (Fig.
3).
(4) Remove the two screws that secure the right
cowl side trim panel to the right front door opening
trim.
(5) Remove the right cowl side trim panel.
(6) Unplug the combination flasher from the junc-
tion block.
Fig. 2 Multi-Function Switch Continuity
GROUP 8M - PASSIVE
STEERING COLUMN,
JUNCTION RIGHT BLOCK COWL TRIM SIDE
OR
Fig. 3 Right Cowl Side Trim Panel Remove/Install
(7) Install the combination flasher by aligning the
flasher terminals with the cavities in the junction
block and pushing the flasher firmly into place.
(8) Connect the battery negative cable.
SCREWS PUSH NUT VIEW FROM TERMINAL CASE
ZG