2 - 12
SUSPENSION
REMOVAL AND INSTALLATION (Continued)
(4) Remove stud from hub with Remover C-4150A
(Fig. 10).
Fig. 10 Wheel Stud Removal
INSTALLATION
(1) Install new stud into hub flange.
(2) Install three washers onto stud, then install
lug nut with the flat side of the nut against the
washers.
(3) Tighten lug nut until the stud is pulled into
the hub flange. Verify that the stud is properly
seated into the flange.
(4) Remove lug nut and washers.
(5) Install the brake rotor and caliper, refer to
Group 5 Brakes for procedure.
(6) Install wheel and tire assembly, use new lug
nut on stud or studs that were replaced.
(7) Remove support and lower vehicle.
SPECIFICATIONS
TORQUE CHART
DESCRIPTION
Shock Absorber
Upper Nut . . . . . . . . . . . . . . . . 23 N·m (17 ft. lbs.)
Lower Nut . . . . . . . . . . . . . . . . 28 N·m (21 ft. lbs.)
Suspension Arm Upper
Nuts . . . . . . . . . . . . . . . . . . . . 75 N·m (55 ft. lbs.)
Suspension Arm Lower
Axle Bracket Nut . . . . . . . . . . 115 N·m (85 ft. lbs.)
Frame Bracket Nut . . . . . . . 176 N·m (130 ft. lbs.)
Stabilizer Bar
Clamp Bolt . . . . . . . . . . . . . . . 54 N·m (40 ft. lbs.)
Link Upper Nut . . . . . . . . . . . 61 N·m (45 ft. lbs.)
Link Lower Bolt . . . . . . . . . . . 95 N·m (70 ft. lbs.)
Track Bar
Ball Stud Nut . . . . . . . . . . . . . 81 N·m (60 ft. lbs.)
Axle Bracket Bolt . . . . . . . . . . 75 N·m (55 ft. lbs.)
Track Bar Bracket
Bolts . . . . . . . . . . . . . . . . . . . 121 N·m (90 ft. lbs.)
Nut . . . . . . . . . . . . . . . . . . . . 121 N·m (90 ft. lbs.)
Support Bolts . . . . . . . . . . . . . 95 N·m (70 ft. lbs.)
Hub Bearing
Bolts . . . . . . . . . . . . . . . . . . . 102 N·m (75 ft. lbs.)
ZG
TORQUE