Liftgate Lock Cylinder Switch; Liftglass Ajar Switch - Jeep 1997 Grand Cherokee Service Manual

LOCK CYLIN- TRIM PANEL LOWER UPPER DER PANEL TRIM LIFTGATE
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Door Lock Cylinder Switch Remove/Install-
Fig. 5 Liftgate Trim Panel Remove/Install
(8) Reverse the removal procedures to install.
Tighten the latch mounting screws to 7 N·m (62 in
lbs.).

LIFTGATE LOCK CYLINDER SWITCH

(1) Disconnect and isolate the battery negative
cable.
DOOR
Typical
ARM SWITCH DIS- TRIM PANEL LOWER UPPER LOCK RETAIN- ING CLIP LOCK PANEL TRIM
VEHICLE THEFT/SECURITY SYSTEMS
Fig. 6 Liftgate Latch/Lock Components
(2) Remove the screws that secure the liftgate
lower trim panel to the liftgate (Fig. 7).
Fig. 7 Liftgate Trim Panel Remove/Install
(3) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the liftgate
around the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(4) Pry the liftgate lock cylinder switch off of the
back of the lock cylinder (Fig. 8).
(5) Unplug the lock cylinder switch wire harness
connector and remove the switch from inside the lift-
gate.
(6) Reverse the removal procedures to install.

LIFTGLASS AJAR SWITCH

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the screws that secure the liftgate
lower trim panel to the liftgate (Fig. 9).
HANDLE LIFTGATE LATCH POWER ACTUATOR LOCK HANDLE LATCH HANDLE ROD
LOCK ROD
8Q - 7