Jeep 1997 Grand Cherokee Service Manual page 447

CCD DATA BUS CONNEC- TOR
GRAY 7–WAY CONNECTOR RADIO
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Radio Remove/Install
Fig. 4 Radio Connectors
(7) If the vehicle is so equipped, remove the screw
that secures the ground wire to the radio chassis and
remove the radio from the vehicle.
(8) Reverse the removal procedures to install.
Tighten the radio mounting screws to 5 N·m (45 in.
lbs.).
REMOTE RADIO SWITCH
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the three screws that secure the driver
airbag module to the steering wheel (Fig. 5).
(3) Pull the airbag module away from the steering
wheel far enough to unplug the airbag and horn
MOUNTING SCREWS
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
MOUNTING SCREWS
SPEED SWITCHES CONTROL FWD
Fig. 5 Driver Airbag Module Remove/Install
switch wire harness connectors from the back of the
airbag module.
(4) Remove the airbag module from the steering
wheel.
(5) Remove the screws that secure the speed con-
trol switches to the steering wheel, and lower the
switches from the steering wheel spokes (Fig. 6).
Fig. 6 Speed Control Switches Remove/Install
(6) Remove the two screws that secure the remote
radio switch to the steering wheel spoke (Fig. 7).
OR
(7) Unplug the wire harness connector from the
remote radio switch.
(8) Remove the remote radio switch from the steer-
ing wheel.
(9) Reverse the removal procedures to install.
Tighten the screws that secure the airbag module to
the steering wheel to 10.2 N·m (90 in. lbs.).
AMPLIFIER
(1) Disconnect and isolate the battery negative
cable.
DRIVER'S AIRBAG MODULE AIRBAG WIRE SCREWS
AUDIO SYSTEMS
HORN SWITCH WIRE
8F - 11