Jeep 1997 Grand Cherokee Service Manual page 542

INBOARD SWITCH POD MOUNT-
8N - 10 ELECTRICALLY HEATED SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or other suitable wide flat-
bladed tool, pry gently around the edges of the
inboard switch pod bezel and remove the bezel.
(3) Remove the three screws that secure the
inboard switch pod to the instrument panel (Fig. 1).
Fig. 1 Inboard Switch Pod Remove/Install
(4) Pull the inboard switch pod out from the
instrument panel far enough to unplug the wire har-
ness connectors.
(5) Remove the inboard switch pod from the
instrument panel.
(6) Reverse the removal procedures to install.
HEATED SEAT CONTROL MODULE
(1) Move the power seat adjuster to its full up and
full forward stop positions.
(2) Remove the three screws that secure the seat
side shield to the seat cushion frame.
(3) Pull the seat side shield away from the seat far
enough so that the power recliner adjuster lower
bracket can be seen.
(4) Adjust the seat back with the power recliner
switch so that both of the two bolts in the power
recliner adjuster lower bracket can be accessed.
(5) Disconnect and isolate the battery negative
cable.
(6) Remove the two bolts that secure the power
recliner adjuster lower bracket to the seat cushion
frame.
ING SCREWS
SEAT CUSHION FRAME POWER
(7) Gently pry the power recliner adjuster lower
bracket upwards to access the heated seat control
module mounting screw (Fig. 2).
SEAT CUSHION FRAME HEATED
Fig. 2 Heated Seat Control Module Remove/Install
(8) Remove the heated seat control module mount-
ing screw from the seat cushion frame.
(9) Reach under the rear of the seat cushion to
lower the heated seat control module and mounting
bracket unit from the inside of the seat cushion
frame (Fig. 3).
Fig. 3 Heated Seat Control Module
(10) Unplug the heated seat control module wire
harness connector and remove the module from
under the seat.
(11) Reverse the removal procedures to install.
Tighten the power recliner adjuster lower bracket
bolts to 28 N·m (20 ft. lbs.).
ADJUSTER RECLINER MODULE HEATED SEAT MOUNTING CONTROL
SEAT CONTROL MODULE
ZG
SCREW