Power Window Switch; Power Window System; Removal And Installation; Power Window Motor - Jeep 1997 Grand Cherokee Service Manual

MEMORY SWITCH POWER MOUNTING SCREWS CONNECTOR CONNECTOR MIRROR FWD
8S - 6 POWER WINDOW SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Door Module Remove/Install
NOTE: If a new door module is installed, the pro-
grammable features must be enabled and/or dis-
abled to the customer's preferred settings. Use a
DRB scan tool and the proper Body Diagnostic Pro-
cedures manual to perform these operations.

POWER WINDOW SWITCH

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 4).
Fig. 4 Rear Door Trim Panel Remove/Install
DOOR MODULE REAR DOOR U-NUT TRIM PANEL PLUG CON- NECTOR 12–WAY BEZEL REAR POWER SLIDE
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(6) Unplug the wire harness connector from the
door power window switch.
(7) Unsnap the switch from the receptacle in the
trim panel (Fig. 5).
Fig. 5 Rear Door Power Window Switch Remove/
(8) Reverse the removal procedures to install.

POWER WINDOW MOTOR

FRONT DOOR
(1) Remove the front door trim panel as described
under Door Module in this group.
(2) Remove the watershield from the inner door
panel.
(3) Loosen the two nuts that secure the door glass
to the window regulator lift plate (Fig. 6).
Fig. 6 Glass Attaching Nuts
WINDOW SWITCH LOOSEN 2 NUTS
Install
PANEL REAR DOOR TRIM RECEPTACLE SWITCH
ZG