Set Lamp - Jeep 1997 Grand Cherokee Service Manual

ZG
REMOVAL AND INSTALLATION (Continued)
(10) Install the right cowl side trim and the fuse
access panel.
HORN RELAY
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the cover from the Power Distribution
Center (PDC) (Fig. 14).
Fig. 14 Power Distribution Center
(3) Refer to the label on the PDC for horn relay
identification and location.
(4) Unplug the horn relay from the PDC.
(5) Install the horn relay by aligning the relay ter-
minals with the cavities in the PDC and pushing the
relay firmly into place.
(6) Install the PDC cover.
(7) Connect the battery negative cable.
(8) Test the relay operation.

SET LAMP

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
GROUP 8M - PASSIVE
STEERING COLUMN,
VEHICLE THEFT/SECURITY SYSTEMS
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Using a wide flat-bladed tool such as a trim
stick, pry the cowl top trim panel off of the instru-
ment panel top pad (Fig. 15).
Fig. 15 Cowl Top Trim Remove/Install
(3) If the vehicle is so equipped, pull the panel up
far enough to unplug the wire harness connector
from the solar sensor, or to remove the solar sensor
from the cowl top trim between the passenger side
and center defroster outlets.
(4) Remove the cowl top trim panel from the vehi-
cle.
(5) Remove the auto headlamp light sensor/vehicle
theft security system set lamp mounting screw near
the driver side defroster duct outlet.
(6) Pull the lamp up far enough to unplug the wire
harness connector and remove the lamp.
OR (7) Reverse the removal procedures to install.
8Q - 11