Jeep 1997 Grand Cherokee Service Manual page 449

U-NUT
FRONT DOOR
U-NUT
ZG
REMOVAL AND INSTALLATION (Continued)
(7) Remove the speaker from the instrument
panel.
(8) Reverse the removal procedures to install.
FRONT DOOR
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the screw located in the bezel opening
near the inside door latch release handle that secures
the trim panel to the inner door panel (Fig. 11).
Fig. 11 Front Door Trim Panel Remove/Install
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Remove the trim cap and screw at the upper
front corner of the trim panel.
(6) Remove the screw located above the front door
speaker grille.
(7) Using a wide flat-bladed tool such as a trim
stick, gently pry the trim panel away from the door
around the perimeter to release the trim panel
retainers.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(8) Pull the trim panel away from the inner door
panel far enough to unplug the wire harness connec-
tors from the door module and, if the vehicle is so
equipped, from the door courtesy lamp.
(9) Remove the three screws that secure the
speaker to the lower front corner of the inner door
panel (Fig. 12).
(10) Pull the speaker away from the inner door
panel far enough to unplug the speaker wire harness
connector.
(11) Remove the speaker from the door.
LOCK POWER COURTESY KEY CYLINDER SWITCH CONNECTOR MOTOR CONNECTOR LAMP SCREW POWER FWD DOW MOTOR WIN-
Fig. 12 Front Door Speaker Remove/Install
(12) Reverse the removal procedures to install.
Tighten the hardware as follows:
• Speaker mounting screws - 1.1 N·m (10 in. lbs.)
• Trim panel mounting screws - 1.3 N·m (12 in.
lbs.).
REAR DOOR
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the screw located in the bezel opening
near the inside door latch release handle that secures
the trim panel to the inner door panel (Fig. 13).
Fig. 13 Rear Door Trim Panel Remove/Install
SPEAKER POWER LOCK/WINDOW SWITCH POWER MIRROR SWITCH CON- REAR DOOR U-NUT TRIM PANEL PLUG PLASTIC NUT CONNECTOR ROR POWER
AUDIO SYSTEMS
CONNEC- NECTOR BEZEL MIR- TOR
8F - 13