Jeep 1997 Grand Cherokee Service Manual page 392

GAUGE MOUNTING
8E - 26 INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
GAUGE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the cluster lens, hood, and mask as
described in this group.
(2) Remove the screws that secure the gauge(s)
from the rear of the cluster circuit and gauge housing
(Fig. 7).
(3) Remove the gauge(s) from the front of the clus-
ter circuit and gauge housing.
(4) Reverse the removal procedures to install.
CLUSTER BULB
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
SCREWS
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
Fig. 7 Gauge Mounting Screws
(1) Remove the instrument cluster as described in
this group.
(2) Remove the bulb and holder from the rear of
the cluster housing by turning the holder counter-
clockwise (Fig. 8).
(3) Unplug the bulb from the holder.
OR
CAUTION: Always use the correct bulb size and
type for replacement. An incorrect bulb size or type
may overheat and cause damage to the instrument
cluster printed circuit and/or the gauges.
(4) Reverse the removal procedures to install.
OUTBOARD SWITCH POD
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the cluster bezel as described in this
OR
group.
(2) Remove the two screws that secure the out-
board switch pod to the instrument panel (Fig. 9).
(3) Pull the outboard switch pod out from the
instrument panel far enough to unplug the wire har-
ness connectors.
GAUGE MOUNTING SCREWS
TO GROUP 8M -
BEFORE ATTEMPTING
STEERING COLUMN,
ZG
PASSIVE
OR