Jeep 1997 Grand Cherokee Service Manual page 500

LOCKRING
8L - 10 LAMPS
REMOVAL AND INSTALLATION
CARGO LAMP BULB . . . . . . . . . . . . . . . . . . . . 12
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . 11
DOME LAMP BULB . . . . . . . . . . . . . . . . . . . . . 12
DOOR COURTESY LAMP BULB
FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . 10
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . 10
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . 11
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Lift hood to access lamps.
If clearance is minimal behind the headlamp
assembly, refer to the Headlamp Removal/Installa-
tion procedure for bulb replacement.
(2) Reach into engine compartment and locate lock
ring supporting the headlamp bulb assembly.
(3) Rotate the lock ring 1/8 turn counterclockwise
(Fig. 1).
(4) Pull the bulb straight out from the housing.
Fig. 1 Headlamp Bulb
CONNECTOR BULB ASSEMBLY
LAMP BULB SERVICE
page
. . . . . . . . . . . 12
ADJUSTMENT SCREW FOG LAMP
INDEX
OVERHEAD CONSOLE READING LAMP BULB . . 12
PARKING LAMP BULB . . . . . . . . . . . . . . . . . . . 11
READING LAMP BULB . . . . . . . . . . . . . . . . . . . 12
TAIL, STOP, TURN SIGNAL, BACK-UP AND
SIDE MARKER LAMP BULBS . . . . . . . . . . . . 11
TURN SIGNAL AND SIDE MARKER LAMP BULB . 11
UNDERHOOD LAMP BULB
VISOR VANITY LAMP BULB . . . . . . . . . . . . . . . 12
INSTALLATION
CAUTION: Do not touch the bulb glass with fin-
gers or other oily surfaces. Reduced bulb life will
result.
(1) Install new bulb.
(2) Position bulb assembly in the lamp housing
and turning the lock ring 1/8 turn clockwise to
secure.
FOG LAMP BULB
REMOVE
(1) Remove the screws attaching the access cover
to the bottom of the fog lamp (Fig. 2).
(2) Remove spring clip securing bulb to fog lamp.
(3) Disconnect wire connectors at bulb.
(4) Remove bulb element from fog lamp.
Fig. 2 Fog Lamp Bulb
ACCESS COVER CLIP BULB SOCKET BRACKET
ZG
page
. . . . . . . . . . . . . . . 11