Removal And Installation; Door Module - Jeep 1997 Grand Cherokee Service Manual

FRONT DOOR TRIM PANEL BEZEL U-NUT U-NUT PLUG FWD
8T - 4 POWER MIRROR SYSTEMS
DIAGNOSIS AND TESTING (Continued)
replace the faulty power mirror. If not OK, repair the
circuits to the automatic day/night mirror as
required.
NO MIRROR MEMORY
For diagnosis of the memory system, the use of a
DRB scan tool and the proper Body Diagnostic Pro-
cedures manual are recommended.

REMOVAL AND INSTALLATION

DOOR MODULE

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 2).
Fig. 2 Front Door Trim Panel Remove/Install
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Remove the trim cap and screw at the upper
front corner of the trim panel.
(6) Remove the screw located above the front door
speaker grille.
(7) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
MEMORY SWITCH POWER MOUNTING SCREWS CONNECTOR CONNECTOR MIRROR
(8) Unplug the wire harness connectors from the
door module and the door courtesy lamp, if equipped.
(9) Remove the five screws that secure the door
module to the door trim panel (Fig. 3).
Fig. 3 Door Module Remove/Install
(10) Remove the door module from the trim panel.
(11) Reverse the removal procedures to install.
NOTE: If a new door module is installed, the pro-
grammable features must be enabled and/or dis-
abled to the customer's preferred settings. Use a
DRB scan tool and the proper Body Diagnostic Pro-
cedures manual to perform these operations.
DOOR MODULE CON- NECTOR 12–WAY
ZG