Jeep 1997 Grand Cherokee Service Manual page 451

SCREW
SOUND BAR
TWEETER
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 16 Sound Bar Remove/Install
(3) Remove the five screws that secure the sound
bar to the upper liftgate opening reinforcement.
(4) Lower the sound bar far enough to unplug the
wire harness connector near the right end of the
sound bar.
(5) Remove the sound bar from the vehicle.
(6) Reverse the removal procedures to install.
When installing the sound bar, be certain to reinstall
a spacer on each screw between the sound bar and
the upper liftgate opening reinforcement.
ANTENNA
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
FIXED ANTENNA
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the right front inner fender liner. Refer
to Group 23 - Body for the procedures.
(3) Unscrew the antenna mast from the antenna
body (Fig. 17).
(4) Remove the antenna cap nut and adapter using
an antenna nut wrench (Special Tool C-4816) (Fig.
18).
(5) Lower the antenna body and cable assembly
through the fender far enough to access the antenna
body through the right front fender wheel housing
(Fig. 19).
(6) Remove the fuse access panel in the right cowl
side trim panel, and remove the push nut that
secures the trim panel to the junction block (Fig. 20).
GROUP 8M - PASSIVE
STEERING COLUMN,
ADAPTER
CAP NUT
TOOL ANTENNA MAST
Fig. 17 Fixed Antenna Mast Remove/Install- Typical
OR
Fig. 18 Fixed Antenna Cap Nut and Adapter
Remove/Install - Typical
(7) Remove the two screws that secure the right
cowl side trim panel to the front door opening trim
and remove the cowl side kick panel trim.
(8) Locate the antenna coaxial cable connector
near the junction block at the right cowl side panel.
Unplug the connector by pulling it apart while twist-
ing the metal connector halves (Fig. 21). Do not pull
on the cable.
(9) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel. Access the
grommet from inside the right front fender wheel
housing.
(10) Pull the coaxial cable out through the right
cowl side outer panel and remove the antenna body
and cable from the vehicle.
(11) Reverse the removal procedures to install.
Tighten the antenna cap nut to 7.9 N·m (70 in. lbs.).
Tighten the antenna mast to 3.3 N·m (30 in. lbs.).
POWER ANTENNA
(1) Disconnect and isolate the battery negative
cable.
ANTENNA ADAPTER CAP NUT
AUDIO SYSTEMS 8F - 15