Jeep 1997 Grand Cherokee Service Manual page 339

SENSOR HARNESS BATTERYTRAY
ZG
REMOVAL AND INSTALLATION (Continued)
BATTERY TEMPERATURE SENSOR
The battery temperature sensor is located under
vehicle battery (Fig. 6) and is attached to a mounting
hole on battery tray.
Fig. 6 Battery Temperature Sensor Location
SPECIFICATIONS
GENERATOR RATINGS
TYPE PART NUMBER
DENSO 56005685
DENSO 56005686
DENSO 56027912
DENSO 56027913
TORQUE SPECIFICATIONS
Description
Generator Mounting Bolt—
5.2L/5.9L Engines . . . . . . . . . . 41 N·m (30 ft. lbs.)
Generator Pivot Bolt/Nut—
.2L/5.9L Engines . . . . . . . . . . . 41 N·m (30 ft. lbs.)
Generator Mounting Bolt—
4.0L Engine . . . . . . . . . . . . . . 55 N·m (41 ft. lbs.)
Generator Pivot Bolt/Nut—
4.0L Engine . . . . . . . . . . . . . . 55 N·m (41 ft. lbs.)
Battery Terminal Nut . . . . . . . . 8.5 N·m (75 in. lbs.)
Ground Terminal Nut . . . . . . . . 8.5 N·m (75 in. lbs.)
Harness Hold-down Nut . . . . . . 8.5 N·m (75 in. lbs.)
Field Terminal Nuts . . . . . . . . . 2.8 N·m (25 in. lbs.)
BATTERY TEMPERATURE SENSOR ING HARNESS ENGINE WIR-
RATED SAE AMPS
117
136
117
136
Torque
REMOVAL
(1) Remove battery. Refer to Group 8A, Battery for
procedures.
(2) Disconnect sensor pigtail harness from engine
wire harness.
(3) Pry sensor straight up from battery tray
mounting hole.
INSTALLATION
(1) Feed pigtail harness through hole in top of bat-
tery tray and press sensor into top of battery tray.
(2) Connect pigtail harness.
(3) Install battery. Refer to Group 8A, Battery for
procedures.
ENGINES
4.0L
4.0L
5.2L/5.9L
5.2L/5.9L
CHARGING SYSTEM
MINIMUM TEST AMPS
90
120
90
120
8C - 7