Jeep 1997 Grand Cherokee Service Manual page 578

8R - 6 POWER SEAT SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Power Seat Remove/Install - Typical
(9) Remove the three screws that secure the out-
board seat cushion side shield to the seat cushion
frame and pull the shield away from the seat cush-
ion.
(10) Remove the four nuts that secure the upper
seat adjuster mounting rails to the seat cushion
frame.
(11) Unplug the wire
required, depending
equipped, to separate the power seat motors and
adjuster from the seat cushion frame.
(12) Reverse the removal procedures to install.
Tighten the seat mounting hardware as follows:
• Seat cushion frame to adjuster nuts - 20 N·m (15
ft. lbs.)
• Seat adjuster to floor pan bolts - 29 N·m (20 ft.
lbs.).
POWER RECLINER ADJUSTER AND MOTOR
(1) Move the power seat adjuster to the most
raised and forward stop positions, if possible.
(2) Remove the three screws that secure the out-
board seat cushion side shield to the seat cushion
frame and pull the shield away from the seat so that
the power recliner adjuster lower bracket can be
seen.
(3) If possible, adjust the seat back with the power
recliner switch far enough so that both of the two
bolts in the power recliner adjuster lower bracket can
be accessed.
(4) Disconnect and isolate the battery negative
cable.
FWD POWER SEAT SCREWS (4)
harness connectors
upon how the vehicle
SEAT SEAT SEAT BACK FRAME CUSHION BACK FRAME POWER
(5) Remove the two bolts that secure the power
recliner adjuster lower bracket to the seat cushion
frame (Fig. 5).
Fig. 5 Power Recliner Lower Bracket Remove/Install
(6) Remove the inboard seat back pivot bolt.
(7) Unplug the wire harness connectors, depending
upon how the vehicle is equipped, as required to
remove the seat back from the seat cushion.
(8) Remove the seat back cover far enough to
access the two bolts that secure the power recliner
adjuster upper bracket to the seat back frame (Fig.
6). Refer to Group 23 - Body for the seat back cover
removal procedures.
as
is
Fig. 6 Power Recliner Upper Bracket Remove/Install
(9) Remove the power recliner adjuster and motor
unit from the seat back frame.
(10) Reverse the removal procedures to install.
Tighten the hardware as follows:
• Inboard pivot bolt - 40 N·m (29 ft. lbs.)
• Recliner bracket bolts - 28 N·m (20 ft. lbs.).
POWER LUMBAR ADJUSTER AND MOTOR
(1) Remove the power recliner adjuster and motor
from the seat back frame as described in this group.
(2) Remove all of the seat back trim from the seat
back. Refer to Group 23 - Body for the procedures.
ADJUSTER RECLINER MODULE HEATED RECLINER SEAT MOUNTING CONTROL DUON COVER SCREW
ZG