Jeep 1997 Grand Cherokee Service Manual page 452

ANTENNA LEAD
CAPNUT
JUNCTION RIGHT BLOCK COWL TRIM SIDE MAST SCREWS
8F - 16 AUDIO SYSTEMS
REMOVAL AND INSTALLATION (Continued)
Fig. 19 Fixed Antenna Body and Cable Remove/
Fig. 20 Right Cowl Side Trim Panel Remove/Install
(2) Remove the right front inner fender liner. Refer
to Group 23 - Body for the procedures.
(3) Remove the antenna cap nut and escutcheon
using an antenna nut wrench (Special Tool C-4816)
(Fig. 22).
(4) Remove the fuse access panel in the right cowl
side trim panel, and remove the push nut that
secures the trim panel to the junction block (Fig. 20).
PUSH NUT
Install
ANTENNA LEAD ANTENNA
Fig. 21 Antenna Coaxial Cable Connector -Typical
Fig. 22 Power Antenna Remove/Install
(5) Remove the two screws that secure the right
cowl side trim panel to the front door opening trim
and remove the cowl side kick panel trim.
(6) Locate the antenna coaxial cable connector
near the junction block at the right cowl side panel.
Unplug the connector by pulling it apart while twist-
ing the metal connector halves (Fig. 21). Do not pull
on the cable.
(7) Unplug the power antenna wire harness con-
nector from the junction block.
(8) Remove the antenna mounting bolts (Fig. 22).
(9) Disengage the coaxial cable grommet from the
hole in the right cowl side outer panel. Access the
grommet from inside the right front fender wheel
housing.
LEAD ESCUTCHEON CAPNUT POWER ANTENNA BOLT (2)
ZG