Jeep 1997 Grand Cherokee Service Manual page 432

8E - 30 INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(1) Disconnect and isolate the battery negative
cable.
(2) Drill out the two rivets that secure the glove
box hinge to the lower edge of the glove box module
(Fig. 17).
NOTE: The rivets are used to ease assembly during
the manufacturing process, but do not require
replacement following service.
Fig. 17 Glove Box Remove/Install
(3) Remove the four screws that secure the glove
box hinge to the instrument panel armature.
(4) Release the glove box latch and remove the
glove box from the glove box module.
(5) Reverse the removal procedures to install.
GLOVE BOX COMPONENTS
The glove box bezel is the only component of the
glove box that can be serviced without glove box
removal. All other components will require that the
glove box be removed from the glove box module as
described in this group.
GLOVE BOX BEZEL
(1) Open the glove box.
(2) Remove the two screws that secure the bezel at
the top of the glove box inner door panel (Fig. 18).
Fig. 18 Glove Box Components
(3) Carefully pry the bezel away from the outside
of the glove box door. There is double-faced adhesive
tape between the bezel and the outer door panel.
(4) Reverse the removal procedures to install.
GLOVE BOX HINGE
(1) Remove the glove box as described in this
group.
(2) Remove the screws that secure the glove box
hinge to the glove box inner door panel.
(3) Remove the glove box hinge.
(4) Reverse the removal procedures to install.
GLOVE BOX BIN
(1) Remove the glove box as described in this
group.
(2) Remove the glove box hinge as described in
this group.
(3) Remove the screws that secure each side of the
bin to the glove box door.
(4) Remove the glove box bin.
(5) Reverse the removal procedures to install.
GLOVE BOX LATCH AND HANDLE
(1) Remove the glove box as described in this
group.
(2) Remove the glove box hinge and glove box bin
as described in this group.
(3) Remove the two bezel screws, two latch screws,
and one handle screw from the glove box inner door
panel.
(4) Remove the inner door panel from the glove
box door.
(5) Remove the second glove box latch handle
screw (Fig. 19).
Fig. 19 Glove Box Latch and Handle Remove/Install
(6) Remove the latch and handle from the glove
box door as a unit.
(7) Reverse the removal procedures to install.
GLOVE BOX LOCK CYLINDER
(1) Remove the glove box latch and handle as
described in this group.
(2) Insert the key into the glove box lock cylinder.
ZG