Jeep 1997 Grand Cherokee Service Manual page 125

SPECIAL TOOL C-452 SPECIAL TOOL C-3281
ZG
REMOVAL AND INSTALLATION (Continued)
(5) Using Remover C–452 and Wrench C–3281,
remove the pinion yoke from pinion shaft (Fig. 39).
Fig. 39 Pinion Yoke Removal
(6) Remove the pinion gear from housing (Fig. 40).
Catch the pinion with your hand to prevent it from
falling and being damaged.
Fig. 40 Remove Pinion Gear
YOKE RAWHIDE HAM- MER REMOVER PINION SEAL SPECIAL TOOL 7794A
DIFFERENTIAL AND DRIVELINE
(7) Use Remover 7794-A and slide hammer to
remove the pinion shaft seal (Fig. 41).
(8) Remove oil slinger, if equipped, and front pin-
ion bearing.
(9) Remove the front pinion bearing cup with
Remover C-4345 and Handle C–4171 (Fig. 42).
Fig. 41 Seal Removal
Fig. 42 Front Bearing Cup Removal
SLIDE HAMMER HANDLE
3 - 67