Glove Box; Graphic Display Module And Vehicle; Information Center - Jeep 1997 Grand Cherokee Service Manual

INSTRUMENT PANEL ARMA- TURE OUTBOARD SWITCH
8E - 28 INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
BODY CONTROL MODULE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the knee blocker/steering column cover
as described in this group.
(2) Remove the four screws below the outboard
switch pod that secure the Body Control Module
(BCM) to the instrument panel armature (Fig. 11).
Fig. 11 Body Control Module Remove/Install
(3) Move the BCM towards the steering column far
enough to unplug the three wire harness connectors.
(4) Remove the BCM from the instrument panel.
(5) Reverse the removal procedures to install.
NOTE: If a new Body Control Module is installed,
the programmable features must be enabled and/or
disabled to the customer's preferred settings. Use a
DRB scan tool and the proper Body Diagnostic Pro-
cedures manual to perform these operations.
GLOVE BOX MODULE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
MOUNTING MODULE BODY CONTROL POD DATA SCREWS LINK NECTOR CON-
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
GROUP 8M - PASSIVE
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
OR BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the knee blocker/steering column cover
as described in this group.
(2) Remove the two screws that secure the top of
the instrument panel center bezel to the instrument
panel above the Graphic Display Module (GDM) or
Vehicle Information Center (VIC).
(3) Remove the ash receiver from the instrument
panel center bezel.
(4) Remove the two screws in the back of the ash
receiver opening that secure the instrument panel
center bezel to the instrument panel armature.
(5) Remove the screw that secures the courtesy
lamp located under the outboard end of the glove box
module.
(6) Open the passenger side front door and remove
the screw that secures the outboard end of the glove
box module.
(7) Remove the four screws that secure the glove
box hinge to the instrument panel armature on the
lower edge of the glove box module.
(8) Open the glove box door and remove the four
screws at the top of the glove box opening that secure
the upper edge of the glove box module to the instru-
ment panel armature.
(9) Lower the glove box module far enough to
unplug the wire harness connectors from the glove
box lamp and switch, the cigar lighter and lamp, and
the power outlet. Also remove the ash receiver lamp
bulb and socket as a unit by gently pulling it out of
the ash receiver lamp hood.
(10) Remove the glove box module from the vehi-
cle.
(11) Reverse the removal procedures to install.

GRAPHIC DISPLAY MODULE AND VEHICLE

INFORMATION CENTER

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the glove box module as described in
this group.
BEFORE ATTEMPTING
STEERING COLUMN,
TO GROUP 8M -
BEFORE ATTEMPTING
STEERING COLUMN,
ZG
OR
PASSIVE
OR