Jeep 1997 Grand Cherokee Service Manual page 458

8G - 4 HORN SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(8) Test the relay operation.
HORN SWITCH
WARNING: ON VEHICLES
DRIVER SIDE AIRBAG, THE HORN SWITCH IS INTE-
GRAL TO THE AIRBAG MODULE TRIM COVER.
SERVICE OF THIS COMPONENT SHOULD BE PER-
FORMED ONLY BY
AUTHORIZED DEALER SERVICE TECHNICIANS.
FAILURE TO TAKE THE PROPER PRECAUTIONS
OR TO FOLLOW THE PROPER PROCEDURES
COULD RESULT IN ACCIDENTAL, INCOMPLETE, OR
IMPROPER AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY. REFER TO GROUP 8M - PAS-
SIVE RESTRAINT SYSTEMS FOR THE SERVICE
PROCEDURES.
HORN
(1) Disconnect and isolate the battery negative
cable.
(2) Raise and support the vehicle.
(3) Remove the radiator lower air deflector. Refer
to Group 7 - Cooling System for the procedures.
(4) Unplug the horn wire harness connectors (Fig.
2).
EQUIPPED WITH
CHRYSLER-TRAINED
A
AND
Fig. 2 Horn Remove/Install
(5) Remove the screw that secures the horn
mounting bracket to the radiator closure extension
panel.
(6) Remove the horns and mounting bracket from
the vehicle.
(7) Reverse the removal procedures to install.
Tighten the horn mounting bracket screw to 30 N·m
(22 ft. lbs.).
ZG