Push Button Module; Reading And Courtesy Lamp Bulb; Trip Computer, Compass, And Thermometer Display Module - Jeep 1997 Grand Cherokee Service Manual

MINI OVERHEAD CONSOLE SCREW SCREW
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Overhead Console Remove/Install -Short-Type
TRIP COMPUTER, COMPASS, AND
THERMOMETER DISPLAY MODULE
(1) Remove the overhead console as described in
this group.
(2) Remove the screws that secure the trip com-
puter, compass, and thermometer display module to
the overhead console housing (Fig. 5).
(3) Unplug the lighting and push button wire har-
ness connectors from the trip computer, compass, and
thermometer display module.
(4) Remove the module from the overhead console
housing.
(5) Reverse the removal procedures to install.

PUSH BUTTON MODULE

(1) Remove the overhead console as described in
this group.
(2) Unplug the wire harness connectors from the
push button module.
(3) Remove the four screws (long-type console) or
two screws (short-type console) that secure the push
button module to the console housing.
SNAP CLIPS BRACKET
Fig. 5 Trip Computer, Compass, and
ThermometerDisplay Module Remove/Install -
(4) Remove the push button module from the con-
sole.
(5) Reverse the removal procedures to install.

READING AND COURTESY LAMP BULB

(1) Insert a long, narrow, flat-bladed tool at the
notch on the curved edge of the reading and courtesy
lamp lens.
(2) Gently pry the lens downward from the over-
head console housing and pivot the lens down. It may
be necessary to move the tool along the edge of the
lens to free the lens from the console housing.
(3) Remove the bulb by pulling it straight down
from the lamp socket.
(4) Install a new bulb by aligning its base with the
socket, and pushing the bulb firmly into place.
(5) Pivot the lens back up into position and press
upward firmly until it snaps into place.
(6) Test the lamp by depressing the lens to check
for proper lamp switching and lighting.
OVERHEAD CONSOLE SYSTEMS
Typical
8V - 7