Jeep 1997 Grand Cherokee Service Manual page 587

LOOSEN ONLY REGULATOR SCREWS LOOSEN ONLY
ZG
REMOVAL AND INSTALLATION (Continued)
(4) Slide the door glass rearward to remove it from
the nuts.
(5) Pull the door glass to the full up position and
tape the glass to the upper door window frame.
(6) Unplug the wire harness connector from the
power window motor.
(7) Remove the four screws that secure the window
regulator to the inner door panel (Fig. 7).
Fig. 7 Front Door Window Regulator Remove/Install
(8) Loosen the last two screws that secure the reg-
ulator to the inner door panel.
(9) Remove the window regulator and motor
assembly from inside the door.
(10) To install, place the window regulator inside
the door and slide the two loose screws into the slot-
ted holes in the door inner panel.
(11) Install the remaining regulator mounting
screws and tighten to 12 N·m (105 in. lbs.).
(12) Remove the tape used to secure the glass to
the upper door window frame and lower the glass.
Move the glass as far rearward into the channel as
possible and push down. Tighten the two loose win-
dow regulator screws to 12 N·m (105 in. lbs.).
(13) Attach the door glass by sliding the two nuts
into the slotted holes on the regulator lift plate.
Tighten the nuts to 12 N·m (105 in. lbs.).
(14) Plug in the wire harness connector to the
power window motor.
(15) Use an adhesive/sealant to install the plastic
watershield to the door inner panel.
(16) Reverse the remaining removal procedures to
complete the installation.
REAR DOOR
(1) Remove the rear door trim panel as described
under Power Window Switch in this group.
(2) Remove the watershield from the inner door
panel.
(3) Loosen the two nuts that secure the door glass
to the window regulator lift plate (Fig. 8).
ATTACHING CHANNEL SCREWS REGULATOR LOOSEN ONLY SCREWS
LOOSEN
ONLY
POWER WINDOW SYSTEMS
Fig. 8 Glass Attaching Nuts
(4) Slide the door glass forward to remove it from
the nuts.
(5) Pull the door glass to the full up position and
tape the glass to the upper door window frame.
(6) Unplug the wire harness connector from the
power window motor.
(7) Remove the four screws that secure the window
regulator to the inner door panel (Fig. 9).
Fig. 9 Rear Door Window Regulator Remove/Install
(8) Loosen the last two screws that secure the reg-
ulator to the inner door panel.
(9) Remove the window regulator and motor
assembly from inside the door.
(10) To install, place the window regulator inside
the door and slide the two loose screws into the slot-
ted holes in the door inner panel.
(11) Install the remaining regulator mounting
screws and tighten to 12 N·m (105 in. lbs.).
(12) Remove the tape used to secure the glass to
the upper door window frame and lower the glass.
Move the glass as far rearward into the channel as
LOOSEN 2 NUTS S LIDE CHANNEL ATTACH- ING SCREW
8S - 7