Setting Up The Printer For Wireless Lan Wpa-Enterprise - Xerox WorkCentre 3615 System Administrator Manual

Static IP enables the system administrator to assign an IP address to the printer.
−
• If you selected Static IP, enter an IP Address that is in the range of the IP address of the
access point or router.
• Enter the Network Mask, and Gateway Address.
If you need a specific IPv6 address, under IPv6 Settings, select Use Manual Address, then
•
enter the IP Address and Gateway Address.
Note: If the network and wireless router are IPv6 compatible, the router assigns an IPv6 address as
appropriate. Do not use Manual Address unless you are experienced assigning and using IPv6
addresses.
12. Click Next.
13. At Confirm the Settings, select your Panel Language, then click Apply.
If any of the settings are incorrect, click the Back button to return to the previous screen.
14. To print a record of the IP settings, click Print Printer Settings.
15. Click Finish.
When the printer restarts, it uses the information from Printer Setup Utility to connect with the
wireless router.
16. If the Ethernet cable is connected to the printer, disconnect it.
17. Wait approximately two minutes, then print a Configuration Report to check the connection.
If the printer does not successfully connect with the wireless network, check your network
information and try again.

Setting Up the Printer for Wireless LAN WPA-Enterprise

WPA-Enterprise Encryption is supported only when Infrastructure is selected as the Network Type in the
Wi-Fi settings section.
Note: To manage digital certificates, enable the HDD Data Encryption and HTTPS communication.
1. Import the certificate to use with the wireless LAN. For details, see Importing a Digital Certificate.
Note: Use Internet Explorer to import the certificate from Windows. Use Safari to import certificates
from Macintosh.
2. Configure the digital certificate Purpose for wireless LAN (server or root certificate). For details, see
Configuring the Digital Certificate Purpose.
3. Verify the Certificate Authorities within the Category. For details, see Verifying the Digital
Certificate Purpose.
4. Configure WPA-Enterprise for PEAPVO-MS-CHAPV2, EAP-TLS, EAP-TTLS PAP, or EAP-TTLS CHAP.
a. At your computer, open a Web browser, in the address field, type the IP address of the printer,
then press Enter or Return.
b. Click Properties.
In the left navigation panel, scroll down to Physical Connection, then select Wi-Fi.
c.
d. Configure the SSID.
e. At Network Type, select Infrastructure.
® ®
Xerox WorkCentre 3615 Black and White Multifunction Printer
Network Connectivity
System Administrator Guide
39