Hp Storeall 8800 Storage System Configurations - HP StoreAll Series Installation Manual

Figure 4 HP StoreAll 8200 Gateway system with 10 GbE network ports (rear)
1. Slot 1 (blank)
2. Slot 2 — FC HBA (3PAR connection)
3. Slot 3 — FC HBA (optional tape connection)
4. Slot 4 (blank)
5. Slot 4 — 10 GbE NICs (ports 1–2 from right to left)

HP StoreAll 8800 Storage system configurations

The HP StoreAll 8800 supports the following configurations:
HP StoreAll 8800 couplet configured with HP Enterprise (ENT) SAS capacity blocks
HP StoreAll 8800 couplet configured with HP Midline (MDL) SAS capacity blocks
HP StoreAll 8800 couplet configured with both HP ENT SAS and MDL SAS capacity blocks
NOTE: For specific hardware details for each configuration, see the HP StoreAll 8000 Storage
QuickSpecs, available at:
14792_na.pdf.
See the following diagrams for possible configurations of the HP StoreAll 8000 Storage system,
12 Setting up and installing HP StoreAll hardware
http://h18004.www1.hp.com/products/quickspecs/14792_na/
6 Slot 6 — 10 GbE NICs (ports 1–2 from right to left)
7. iLO port
8. eth0 (port 1) — for management network
9 eth1 (port 2) — for management network