HP StoreAll Series Installation Manual page 61

created. The first half of ports (right-side ports) on each NIC in node slots 5 and 6 are
used for Bond0, and the remaining ports (left side ports) are used for Bond1.
For the quad cards, the two ports on the right side of each slot/card is bond0. See flat
and dual networking information in
93xx Storage systems" (page
Advanced Networking (custom configuration for more complex setups): Use this option
to create a custom network for complex configurations. You may configure NIC ports, as
needed, with this option.
7. (For HP StoreAll 9320 and 9300 Storage systems only.) Do one of the following:
If you selected Flat Networking (combined cluster/user network) or Dual Networking
(separate cluster and user network) in
If you selected Advanced Networking (customer configuration for more complex setups)
in Step 6, then go to
8. (For HP StoreAll 9320 and 9300 Storage systems only.) Complete the Network Configuration
wizard screen(s):
IP Address: The IP address is the address of the server on Bond0. For a single network
installation, this is the physical address of this node. For a multiple network installation,
this is the address of the blade on the management network.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the netmask
entry may need to be modified, based on your specific network subnets.
Configuring initial and subsequent nodes on HP StoreAll 8xxx and 93xx Storage systems
"Before you begin configuring HP StoreAll 8xxx and
55).
Step
Step 10.
6, then go to Step 8.
61