HP StoreAll Series Installation Manual page 63

NOTE: When the User Info! screen appears, the default bond mode displayed for 1
GbE Network Storage Gateway systems is Mode 6; however, HP recommends using
Mode4 instead. Be sure to access the Advanced Networking screen, and then change
the bond mode accordingly.
c. Review your selections on the Network Configuration wizard screen(s).
Table 15 (page 63)
display, based on selections that you made in
Table 15 Network Configuration wizard completion requirements
If on the Network
Configuration for HP
StoreAll Data Access screen
you selected...
Flat
Networking
1. √
2. √
3.
4.
An example Network Configuration wizard screen is shown in
Depending on your selections on the Network Configuration for HP StoreAll Data Access
and Network Configuration for iLO Access screens, either Bond0, Bond1, or Bond2 is
indicated at the top of Network Configuration wizard screen(s).
Figure 40 Network Configuration for Bond0 screen
NOTE: You will be prompted to enter details for Bond1 after you enter details for Bond0.
d. Complete the Network Configuration screen(s):
IP Address: The IP address is the address of the server on Bond0. For a single network
installation, this is the physical address of this node. For a multiple network installation,
this is the address of the blade on the management network.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the
netmask entry may need to be modified, based on your specific network subnets.
Configuring initial and subsequent nodes on HP StoreAll 8xxx and 93xx Storage systems
shows which Network Configuration wizard screen(s) automatically
And if on the Network
Configuration for iLO
Access screen you
selected...
Dual Cluster
Networking Network
√
√ √
√
Step 6 and Step 9.
Then you will be required to complete the
following Network Configuration
wizard(s)...
Separate
iLO
Network Bond0
√
√ √
√
√ √
Figure 40 (page
Bond1 Bond2
√
√
√ √
63).
63