HP StoreAll Series Installation Manual page 87

If any of these tests fail, verify the configuration of the OA and VC modules as described on
the failure report displayed on the GUI. If you need to re-enter the IP address for the OA, select
Back to return to the Confirming Onboard Administrator and Virtual Connect Settings screen,
where you can make your changes.
NOTE: If the initialization of the credential manager fails, the GUI displays a message asking
you to initialize the credential manager manually. See
failed" (page 103)
10. Set the iLO IP addresses. On the Get iLO IP Addresses screen, select the method that you want
to use to set up iLO IP addresses. Use the space bar to select or clear the check boxes.
To configure the iLO IP addresses in sequence, enter the first iLO IP address on the Set
iLO IP Addresses screen. For example, if 172.16.3.1 is the starting iLO IP address, the
installer sets the iLO IP addresses in the range 172.16.3.1 to 172.16.3.16 by
incrementing 1 to the last octet of the IP address.
To configure the iLO IP addresses manually, enter each iLO IP address on the Enter iLO
IP Addresses screen.
for more information.
"Credential Manager initialization
Configuring the HP StoreAll 9730 Storage systems 87