HP StoreAll Series Installation Manual page 88

1 1. Note the listed IP addresses on the Confirm iLO IP Addresses screen and select Ok to continue.
12. Configure the chassis interconnect bays (VCs and SAS switches) by specifying whether you
want to configure the Interconnect (IC) IP addresses in sequence or manually from the Get
Interconnect IP Addresses screen. Use the space bar to make a selection, and then select Ok.
13. Do one of the following:
Configure the Interconnect (IC) IP addresses in sequence by entering the first Interconnect
(IC) IP address on the Set Interconnect IP Addresses screen, and then select Ok. The
installer then sets the remainder of the addresses sequentially for all 8 interconnect bays.
For example, if 172.16.3.21 is the starting Interconnect (IC) IP Address, the installer sets
the Interconnect (IC) IP Addresses in the range 172.16.3.21–172.16.3.28.
88 Installing the HP StoreAll OS Software and configuring the HP StoreAll Storage system