HP StoreAll Series Installation Manual page 24

Default bond modes are Mode 1 and Mode 6 because these modes do not require any special
configuration for the network switches. HP recommends using Mode 4 for increased bandwidth
transfer rate by merging all ports into one data path. Using Mode 4 requires additional network
configuration.
The following figures show the network port configuration for HP StoreAll 8800 1 GbE and 10
GbE storage.
Figure 19 HP StoreAll 8800 1 GbE network ports
1. eth7 (port 4)
2. eth6 (port 3)
3. eth5 (port 2)
4.eth4 (port 1)
5. eth8 (port 1)
Figure 20 HP StoreAll 8800 10 GbE network ports
1. eth5 (port 2)
2. eth4 (port 1)
3. eth6 (port 1)
4. eth7 (port 2)
5.eth0 (port 1)
6. eth1 (port 2)
Table 7 (page 25)
supported by the HP StoreAll installation.
24 Setting up and installing HP StoreAll hardware
provides configuration details for default network configurations additionally
6. eth9 (port 2)
7. eth10 (port 3)
8. eth1 1 (port 4)
9. eth0 (port 1)
10. eth1 (port 2)