HP StoreAll Series Installation Manual page 224

10. On the Advanced Configuration screen, do one of the following:
To change the total number of networks, select Back, and then return to
To edit bond modes, select Configure, and then go to
To add bond interfaces, select Continue, and then go to
To reconfigure network configuration, press F2, and then return to
1 1. On the Edit Bond Mode screen, select the appropriate bond mode by using the UP and DOWN
arrow keys or the Tab key on your keyboard, and then select Ok.
Mode=1 (Default): Use this mode to direct all network traffic to one port. Remaining ports
act as a backup, if the designated port fails. Use this option if only a few ports exist in
the network, and the primary intent is to avoid configuration conflicts.
Mode=4 (Recommended): Use this option to balance network traffic across multiple ports.
To use this option, an Ethernet switch configuration is required.
Mode=6 (Optional): Use this option to balance network traffic across all ports and cause
traffic to a given client to be directed to one port. This option is recommended if the switch
cannot be configured.
12. Complete the Add Bond Interface screen, and then select Ok.
13. After the Configuration Summary appears and shows your configuration, review configuration
details, and then select Commit to continue with the installation.
224 Expanding an existing HP StoreAll Storage system using the Setup Wizard
Step
Step 1 1.
Step 12.
Step 7.
8.