HP StoreAll Series Installation Manual page 92

Powers off blades 2–16, applies the SAS configuration, and then reboots blade 1. Log
in to blade 1 when the Linux login prompt appears.
The wizard takes the following actions:
◦
◦
◦
◦
Forms Bond0 from eth0 and eth3.
The X9000 Installation - Network Setup Complete screen appears.
19. On the X9000 Installation - Network Setup Complete screen, select Ok, and then select one
of the following cluster setup methods:.
92 Installing the HP StoreAll OS Software and configuring the HP StoreAll Storage system
Verifies the SAS configuration to ensure that SAS zoning is set up correctly
Powers on blades 2–16
Verifies storage firmware to ensure that is set up correctly
Validates the LUN layout and configures it if necessary