HP StoreAll Series Installation Manual page 54

b. Click Image File.
c. Click Device, and then select the USB device.
d. Click Write to write a date in the image file to the USB device.
The USB flash drive is now bootable with the Quick Restore (QR) image.
3. Insert the USB flash drive into the node on which the HP StoreAll OS Software is to be installed.
4. Boot the node from USB flash drive, press F1 1, and then select option 3.
5. On the Network Storage System screen, enter qr to install the software.
6. Repeat Step 3
NOTE:
or you can use multiple USB flash drives, one for each node.
7. Do one of the following:
If you are installing the current HP StoreAll OS Software version on an HP StoreAll 8200,
8800, 9300, or 9320 Storage system, see
on HP StoreAll 8xxx and 93xx Storage systems" (page 55)
system.
If you are installing the current HP StoreAll OS Software version on an HP StoreAll 9730
Storage system, see
configure your HP StoreAll system.
54 Installing the HP StoreAll OS Software and configuring the HP StoreAll Storage system
to Step 5 on the remaining nodes.
You can use the USB flash drive on one node at a time as you repeat these steps,
"Configuring the HP StoreAll 9730 Storage systems" (page 74)
"Configuring initial and subsequent nodes
to configure your HP StoreAll
to