HP StoreAll Series Installation Manual page 69

16. On the X9000 Installation - Network Setup Complete screen, select one of the cluster setup
methods, select Ok, and then go to the next applicable step.
IMPORTANT: To use the web UI, your cluster network must meet the following conditions:
Network Bond0 was configured without errors.
Broadcast is enabled. The web UI relies on broadcast network traffic.
Broadcast or multicast functions are operational.
You entered a gateway IP address on the Server Setup screen.
If your cluster does not meet these conditions, you must press F2 from the X9000 Installation
- Network Setup Complete screen to complete cluster networking in ASCII mode. See
"Completing the HP StoreAll 8xxx and 93xx server installation by configuring servers and a
cluster in ASCII mode" (page 72)
If you select Join this StoreAll server to an existing cluster, complete the following steps:
1. From the X9000 Installation Network Setup Complete screen, select Join this StoreAll
server to an existing cluster. The Join Cluster screen appears.
Configuring initial and subsequent nodes on HP StoreAll 8xxx and 93xx Storage systems
to complete the installation.
69