Dns/Ftp Screen; File Servers Screen - HP StoreAll Series Installation Manual

If the registration continues to fail, use the text-based installation method to set the VIF. If that fails,
perform the Quick Restore procedure on the system. See
the HP StoreAll OS Software" (page

DNS/FTP screen

DNS and /NTP cannot be set
Probable causes:
The specified DNS/NTP IP addresses are not valid.
The specified domain name is not valid.
A network outage or connectivity situation occurred.
Troubleshooting steps:
Determine whether the specified IP addresses are valid and can be pinged. Run the following
StoreAll command:
dig +short @ <DNS server IP>
If the output is empty or the connection times out, contact the administrator for the DNS/NTP
server. Then, relaunch the wizard to configure the DNS/NTP settings.
If the DNS/NTP IP addresses are valid, the wizard configures them. However, if you want to
set the DNS and NTP manually, use the following Linux command to set the NTP server settings:
ntpdate
To set the DNS server, edit the /etc/resolv.conf file, where:
◦
search <domainname.com>: The search list is normally determined from the local
domain name. By default, it contains only the local domain name.
◦
nameserver <Name-server-IP-address>: Point to your name server or the ISP
name server. You can list up to three name servers.
For example:
search mydomain.comnameserver 201.52.1.10nameserver 202.52.1.11
If the operation still fails, there may be network inconsistencies or an outage. Typically, network
outages lasts only a few minutes. Try the operation later. If the operation continues to fail, contact
your network administrator.
DNS/NTP information cannot be retrieved
Probable cause: The command timed out.
Troubleshooting steps: The network is experiencing inconsistencies or an outage. Usually a network
outage last only a few minutes. Relaunch the wizard and start the operation again.

File Servers screen

IP address is unreachable...message appears on the Configure Bond dialog box
Probable cause:
Intermittent network delays may cause the IP address value to be reported as NULL.
Troubleshooting steps:
If you see this error, click OK to retry configuring the bond. The bond should then be added
successfully.
51).
u <NTP server IP> )
"Creating a bootable device and installing
Troubleshooting the Getting Started Wizard 1 15