Using The New Storage - HP StoreAll Series Installation Manual

16. Do one of the following:
On the Join Cluster screen, all available management consoles will be shown. Select the
applicable management console, and then select Ok to complete the configuration.
If the applicable management console is not listed, select Cancel to display the
Management Console IP screen. Enter the IP address of the management console, and
then select Ok.
The wizard registers and starts a passive management console on the blade.
The installation of the second expansion blade is complete.

Using the new storage

When making new storage available to a cluster, you must complete the following major steps.
This section provides instructions for completing this steps:
1. Verify the vendor storage.
2. Import the new physical volumes into the HP StoreAll database.
3. Extend an existing file system to include the new physical volumes or create a new file system.
Expanding an HP StoreAll Storage 8800/9320 10 GbE cluster with an HP StoreAll 9730 module 227