HP StoreAll Series Installation Manual page 103

6. On the Enclosure Settings screen, select Standby OA, and press OK.
7. On the Network Settings:OA2 screen, navigate to Active IPv4, and press OK.
8. Set the IP address, subnet mask, and gateway (optional), and Accept the changes.
9. On the Network Settings:OA2 screen, navigate to Accept All, and press OK.
A 9370 blade boots, but the Installer cannot ping the VC
After the blade boots, the Installer reports that it cannot ping the VC and the ip addr command
reports only eth0 and eth1. Networks eth[2 7] are not visible.
To correct this situation:
1. Power off the blade.
2. Log in to the VC module from another system on the network.
3. Unassign the blade profile.
4. Reassign the blade profile.
5. Reboot the blade, and continue the installation.
Credential Manager initialization failed
If the default user name or password is changed or the IP address of the OA is changed, the step
to initialize the Credential Manager will fail. To initialize the Credential Manager from the command
line, complete the appropriate procedure.
OA and VC have the same user name and password.
1. Update the OA and VC with their credentials by entering the following StoreAll command:
/opt/hp/platform/bin/hpsp_credmgmt --init-cred
--master-passwd=hpdefault --hw-username=<username>
--hw-password=<password>
2. Update the iLO with its credentials by entering the following StoreAll command:
/opt/hp/platform/bin/hpsp_credmgmt --update-cred
--cred-selector=chassis:global/ilo --cred-type=upwpair
--cred-username=<ilo-username> --cred-password=<ilo-password>
OA and VC have different user names and passwords.
1. Update the OA with its credentials by entering the following StoreAll command:
/opt/hp/platform/bin/hpsp_credmgmt --update-cred
--cred-selector=chassis:chassis/oa --cred-type=upwpair
--cred-username=<username> --cred-password=<password>
2. Update the VC with its credentials by entering the following StoreAll command:
/opt/hp/platform/bin/hpsp_credmgmt --update-cred
--cred-selector=chassis:chassis/vc --cred-type=upwpair
--cred-username=<username> --cred-password=<password>
Configuring the HP StoreAll 9730 Storage systems 103