HP StoreAll Series Installation Manual page 213

The wizard validates the information that you entered, and then:
◦
Pings the active OA
◦
Verifies the OA password
◦
Verifies that OA at that IP address is the active OA
NOTE:
modules as described on the failure report displayed on the GUI. If you need to
re-enter the IP address for the OA, select Back to return to the Confirming Onboard
Administrator and Virtual Connect Settings screen, where you can make your changes.
NOTE: If the initialization of the credential manager fails, the GUI displays a message
asking you to initialize the credential manager manually. See
initialization failed" (page 103)
The wizard verifies the OA firmware.
12. From the Get iLO IP Addresses screen, select the method that you want to use to set up iLO IP
addresses. Use the space bar to make a selection, and then select Ok.
To configure iLO IP addresses in sequence, enter the first iLO IP address on the Set iLO IP
Addresses screen. For example, if 172.16.3.1 is the starting iLO IP address, the installer sets
the iLO IP addresses in the range 172.16.3.1 to 172.16.3.16 by incrementing 1 to the last
octet of the IP address.
To configure the iLO IP addresses manually, enter each iLO IP address on the Enter iLO IP
Addresses screen.
Expanding an HP StoreAll Storage 8800/9320 10 GbE cluster with an HP StoreAll 9730 module
If any of the above tests fail, verify the configuration of the OA and VC
for more information.
"Credential Manager
213