Setting Up The Hp 3Par Storeserv Storage System; Locating The Serial Number - HP 3PAR StoreServ 7200 2-node Manual

3 Setting Up the HP 3PAR StoreServ Storage System

Before you can configure the HP 3PAR StoreServ Storage system, you must initialize it. The Storage
System Setup wizard verifies your HP 3PAR storage system configuration, initializes the storage
system, and runs initialization tests on the storage system.
To set up and configure the HP 3PAR storage system:
1. Verify that the Service Processor is on the same subnet of the network as the HP 3PAR StoreServ
7000 Storage system you are setting up.
2. Click the Set up the Storage System link in SmartStart wizard step 2, Set up systems.
3. Enter the permanent Service Processor IP address. For more information about Service Processor
IP addresses, see the HP 3PAR StoreServ 7000 Storage Installation Guide.
4. Enter the user name setupusr.
5. Enter the password for setupusr that you created in the Service Processor Setup wizard.
Troubleshooting Access
If you cannot access the Storage System Setup wizard, collect the relevant log files and contact
HP support. For more information, see

Locating the Serial Number

The serial number on your HP 3PAR StoreServ Storage system is the seven-digit number located
on the back of the storage system next to the power switch for the node enclosure power cooling
module (PCM1). It begins with "16" (for example, 1612345).
"Troubleshooting System Setup" (page 20).
Locating the Serial Number 17