HP StoreAll Series Installation Manual page 65

10. If you pressed F2 (advanced networking) to change or update networking configurations:
a. Use the Up and Down arrow keys or tab to highlight one of the following options on the
Advanced Configuration screen:
Add Bond Device: Adds a new bond device to the network configuration.
Remove Bond Device: Removes an existing bond device from the network
configuration.
NOTE:
networking selections. If you attempt to delete a bond device needed for the selected
dual or flat networking combination, the following warning screen appears.
If the Delete Confirmation! warning screen appears and you need to create a bond
device, select Yes to be automatically taken to the Advanced Configuration screen,
and recreate the needed bond device(s) for the needed network configuration.
Otherwise, select No.
bondx: Unconfigured: Configures a bond device that has not yet been configured.
If more than one unconfigured device exists, those devices are also listed on the
Advanced Configuration screen.
Press F2 to return to the Network Configuration screen, and then, for HP StoreAll
8200/8800 Storage systems, go to
screen(s); for HP StoreAll 9300/9320 Storage systems, go to
made on the Advanced Configuration screen are disregarded.
b. Do one of the following:
After selecting Add Bond Device, press Enter, and then go to the next step.
After selecting bondx: Unconfigured, select Configure to make device configuration
changes, and then go to
requirements.
Configuring initial and subsequent nodes on HP StoreAll 8xxx and 93xx Storage systems
Table 15 (page 63) lists the minimum bond requirements for dual and flat
Step 9.e
Step 9.e to complete the Network Configuration
to complete the Network Configuration screen
Step 8. Any selections
65