HP StoreAll Series Installation Manual page 97

3. If needed, update the time settings on the Individual Server Setup screen. While setting the
time zone, press Enter while the cursor is positioned in the Time Zone field to display the list
of time zones in a separate screen. Enter the first letter of your time zone, or use the UP and
DOWN arrow keys to find your time zone. Select Ok to accept screen selections.
4. Complete field entry requirements for the Network Configuration screen. Note that on the
Network Configuration screen, the system defines the server on Bond0.
5. Complete the Network Configuration screen(s):
Hostname: The host name (in the above example, Bond0) can include alphanumeric
characters and the hyphen ( ) special character. It is a best practice to use a host name
with only lowercase characters; uppercase characters can cause issues with HP StoreAll
Storage system software. Do not use an underscore (_) in the host name.
IP Address: The IP address is the address of the server on Bond0.
Netmask: The netmask (a 32-bit mask) divides an IP address into subnets and specifies
the available network hosts. This field is auto-filled with 255.255.0.0, but the netmask
entry may need to be modified, based on your specific network subnets.
Default Gateway: The default gateway provides a route between networks. If your default
gateway is on a different subnet than Bond0, skip this field.
VLAN Tag ID: VLAN capabilities provide hardware support for running multiple logical
networks over the same physical networking hardware. HP StoreAll supports the ability
Configuring the HP StoreAll 9730 Storage systems 97