HP StoreAll Series Installation Manual page 214

13. After the wizard lists the IP addresses that you specified on the Confirm iLO IP Addresses
screen, select Ok.
14. On the Get Interconnect IP Addresses screen, configure the chassis interconnect bays (VCs
and SAS switches) by specifying whether you want to configure the Interconnect (IC) IP
addresses in sequence or manually. Use the space bar to select or deselect the check boxes,
and then select Ok.
15. Do one of the following:
Configure the Interconnect (IC) IP addresses in sequence by entering the first Interconnect
(IC) IP address on the Set Interconnect IP Addresses screen, and then select Ok. The
installer then sets the remainder of the addresses sequentially for all 8 interconnect bays.
For example, if 172.16.3.21 is the starting Interconnect (IC) IP Address, the installer sets
the Interconnect (IC) IP Addresses in the range 172.16.3.21–172.16.3.28.
214 Expanding an existing HP StoreAll Storage system using the Setup Wizard