HP StoreAll Series Installation Manual page 90

16. If required, provide the needed input when the following events occur:
The wizard attempts to log in to the Virtual Connect manager using the Administrator
password that you supplied earlier. If the attempt fails, you can retry the attempt or re-enter
the password. (Retry is helpful only if a timeout caused the VC password check to fail.)
When the wizard can log in to the VC manager successfully, it verifies the VC firmware
and asks you to update it, if necessary.
When the firmware is at the correct level, the wizard verifies that the VC is in a default
state.
The wizard configures the VC. The setup process first powers down blades 2- 1 6, and
then powers down blade 1. On blade 1, the power remains off for approximately 3
minutes. Blade 1 then reboots twice.
17. Log in to blade1 again after the Linux login prompt appears.
The wizard makes the following checks:
Pings the VC management IP address
Verifies the hpspAdmin account created earlier
NOTE:
90 Installing the HP StoreAll OS Software and configuring the HP StoreAll Storage system
If a check fails, take the corrective actions described on the GUI.